Stockwell Elastometrics
Blog icon  LinkedIn icon  Twitter icon  Facebook 

icon  YouTube icon  Google+ icon  

The Elastomerics Blog by Stockwell Elastomerics

Wednesday, January 02, 2008

Large Custom Gaskets

Every so often we receive inquiries for large custom gasket. In some case they are extreme such as the one shown below. In many cases they are for NEMA enclosures (commonly NEMA 4). A single piece gasket generally offers the best seal, however many gaskets exceed the width of the material. In this case a jointed corner may be an option.



Single Piece - a single piece gasket will offer consistent deflection force around the gasket. The con to a large single piece gasket is the center waste. If engineer are making multiple gaskets they can create an assembly level drawing that show several gaskets nested.

Joint and Bond – when a single piece is required but the gasket dimensions exceed the material dimensions, a jointed and bonded gasket may be an option. In most cases this is a die or water jet cut male/female dove tail that is then UV bonded. This type of gasket needs to be evaluated to see that the extra labor of bonding does not exceed the material savings. Also, for foams and sponges the corners will be firmer than the gasket material.

Joint (no bonding) – similar to the Jointed and Bonded gasket, a male/female dove tail is die or water jet cut. In this case the gasket is provided in 4 pieces and is mated during installation. In some cases a bond is never required. This is most dependant on the enclosure configuration and the level of sealing required.

Materials most commonly used for large custom gaskets are silicone foam and silicone sponge. Since the sealing area is relatively large (i.e. square inches) the soft nature of these materials allow for lower closure forces to get proper deflection for sealing.

For more information please feel free to contact us at service@stockwell.com or 215-335-3005.




Labels: , , ,


posted by Steve Hughes at 9:33 AM

0 Comments:

Post a Comment

<< Home