Stockwell Elastometrics
Blog icon  LinkedIn icon  Twitter icon  Facebook 

icon  YouTube icon  Google+ icon  

The Elastomerics Blog by Stockwell Elastomerics

Monday, June 13, 2005

17 foot Radome Gasket



We took on a fast-turn project that involved some new capabilities for a customer in the defense electronics sector.

One prototype gasket was needed in one week.. the catch was that the gasket had to be 41" wide x 205" long (17 feet !) with 156, 1.50" diameter holes cut into a 6.0" wide flange.
The requested material was .062" thick closed cell silicone sponge rubber with acrylic adhesive completely coating one side and a 1.0" wide strip of acrylic adhesive on the top side. As the 41" width exceeded the 36" typical material width, we realized splices would be needed.

We suggested R10470-M closed cell silicone sponge from St. Gobain (formerly CHR) spliced to the finished size.
Day 1. The gasket design was received in dxf format, which allowed our Process Engineer, Jay Hough, to design segments approximately 24" long containing the 1.50" diameter holes.
Day 2. After laminating pressure sensitive acrylic adhesive to one side of the R10470-M silicone sponge, the material was water jet cut into the required segments.
Day 3. The gasket was spliced to the final configuration using our new Ultra Violet Light curing station. Loctite's 5091 UV cure silicone adhesive allowed us to work much faster than a traditional moisture cure RTV would have allowed.
Day 4. With the gasket opened up with the adhesive side down, we used a masking fixture to prime the outer 1.0" edge of the top surface to apply a 1.0" wide strip of acrylic pressure sensitive adhesive. An extensible release liner was applied to the top side to permit rolling the gasket on a 6" diameter core for shipping and handling.
Mission accomplished !

posted by Bill Stockwell at 6:12 PM

1 Comments:

Anonymous Anonymous said...

This is a remarkable project, especially considering the size of this gasket and the short turnaround time.
Is there a limit to the size of a gasket?
Is this the biggest gasket that SRC Elastomerics has ever done?

< $BlogCommentDateTime$>  

Post a Comment

<< Home